Try this:
Nah, buat Anda pengguna layanan data dengan ont asal China tersebut, berikut password superadmin Huawei HG8245A yang bisa digunakan. Tentang Huawei HG8245A Huawei HG8245A adalah jenis modem Huawei seri HG8245 yang paling banyak digunakan.
Open your Web Browser (e.g. Internet Explorer, Firefox, Safari)
In the address bar, type 192.168.1.254Press Enter
Enter your Username (the default is admin)Enter your Password (the default is admin)
If the username/password prompt re-appears, you did not enter the correct username and password. Please try again.
If you still cannot log in, you may have previously changed the password.If you previously changed the password and cannot remember it, you will need to factory reset your modem
Select the Maintenance tab on the left side menu
Click AccountWhen prompted, enter your current Username (the default is admin)
Enter your current Password (the default is admin)Enter your new Password and confirm itClick Submit
From this link:
https://www.spark.co.nz/help/internet-data/equipment/huawei/hg630b-gateway/change-the-admin-username...
Huawei Switch console password resetToday i will discuss about / How to Recover Console Port Password in. In this method Clear the Console Login Password in BootROM and Changing the Console Port Password.The BootROM allows you to clear the console port password so that the device does not check the password when you log in through the console port.
When the device starts, you do not need to enter the console port password and all configurations are loaded as normally. After the device starts, change the console port password and save the configuration.NOTICE:. You must restart the device to display the BootROM menu, which results in service interruption.
Migrate services to a backup device and perform this operation in off-peak hours. Set a new password immediately after you log in to the device by clearing console login password. Do not power off the device during the operation. If the switch has two MPUs, remove the standby MPU before restarting the switch. After the switch completes restarting, install the standby MPU.Procedure:Connect a PC to the device through a serial/console cable and restart the device. When the message “Press Ctrl+B to enter Boot Menu” is displayed, press Ctrl+B and enter the password ( [email protected] by default).
Comments are closed.
|
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
March 2023
Categories |